|
200QJ Deep Well Submersible Pump with 32 m³/h Flow, 112 m Head, and 18.5 kW Motor for Clean Water Extraction
32 m³/h Flow Deep Well Submersible Pump
,112 m Head Submersible Well Pump
,18.5 kW Motor 200QJ Pump
The 200QJ deep well submersible pump is engineered for extracting clean water from deep wells and boreholes. It delivers a rated flow of 32 m³/h at a rated head of 112 m, powered by an 18.5 kW (25 HP) motor with a 3-inch discharge outlet. Ideal for groundwater extraction, agricultural irrigation, storage-tank filling, and clean-water supply systems.
| Model | 200QJ |
|---|---|
| Rated Capacity | 32 m³/h |
| Rated Head | 112 m |
| Motor Power | 18.5 kW (25 HP) |
| Outlet Size | 3 inches |
| Minimum Well Diameter | 200 mm |
The pump and submersible motor form a vertical unit operating below water level. Water enters through the submerged inlet, passes through the hydraulic section, and is discharged through the 3-inch outlet into the rising pipe.
- Submerged installation eliminates suction-height limitations and priming requirements
- Compact vertical design fits inside well casing with minimal above-ground space
- Direct lifting of clean water from deep underground sources
Rated operating point is 32 m³/h at 112 m head. Actual output depends on total system head, including dynamic water level, delivery elevation, outlet pressure, and friction losses in the rising pipe and external pipeline.
- Deep-well water extraction
- Agricultural irrigation
- Rural water supply systems
- Storage-tank filling
- Livestock water supply
- Industrial clean-water transfer
- Pipeline pressure boosting
Designed exclusively for clean water. Not suitable for sewage, sludge, long fibres, or liquids containing large solid particles. Water containing excessive sand or corrosive chemicals should be evaluated before pump selection.
- Minimum applicable diameter: 200 mm
- Sufficient water supply to support continuous 32 m³/h flow
- Confirm actual casing diameter, well straightness, static and dynamic water levels before installation
Install vertically below the lowest expected dynamic water level and above sediment at the well bottom. The rising pipe should match the 3-inch outlet and be rated for expected operating pressure.
The 18.5 kW motor requires connection to a suitable control panel with overload, phase-loss, abnormal-voltage, and dry-running protection. Confirm required voltage, frequency, cable size, and starting method according to installation site specifications.
